Big Sound, Tiny Footprint!

Sometimes you need a microphone that's discreet, right? But, you don't want its unobtrusive personality to give you equally thin & skinny sounds. That's why you trust the pros over at Audix and their amazing MicroBoom MB5050! The entire MicroBoom series is all about giving you huge-sounding performance, in a super-slim form factor. This particular MicroBoom features a 50" carbon fiber boom arm that'll attach to any microphone stand. At one end, there's a mini hypercardioid condenser microphone to pick up an orchestra, choir, drum kit, room... whatever you want to capture. Internally, there's a high-quality Mogami cable that terminates to a mini-XLR connector. No messy cable tangles! In fact, there's even a built-in preamp, so you won't have to mess with one.

When you want an ultra-clean, pro-level appearance onstage or in the studio, you've got to go with the MicroBoom MB5050. The truth? It sounds just as ultra-clean and professional as it looks.

Audix MicroBoom MB5050 Features at a Glance:
MicroBoom Stand

• Less than .3 inches diameter
  
• 2.5 ounces
  
• 50" length
  
• Made of Carbon Fiber

M1250 Condenser Microphone:

• Transducer Type: Condenser
  
• Frequency Response: 80 Hz - 20 kHz
  
• Polar Pattern: Hypercardioid
  
• Output Impedance: 150 ohms
  
• Sensitivity at 1k: 7.8 mV/ Pa (-42 dbV +/-1.5 dB)
  
• Recommended Load Impedance: > 1000 ohms
  
• Signal/Noise Ratio (A-weighted): 73 dB
  
• Equivalent Noise Level (A-weighted): 21 dB
  
• Maximum SPL @ .5% THD: 150 dB
  
• Dynamic Range: 129 dB
  
• Power Requirements: 48 - 52 V
  
• Connector: 3 pin mini-XLRm
  
• Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3
  
• Housing / Finish: Brass / paint
  
• Weight: .6 oz / 17 grams
  
• Length: 1.97 inches / 50 mm