Two Mic Sounds, One AWESOME Mic!
Check this bad boy out! That's right, sE's been breaking the rules again. This time, they've gone and taken one of their hottest tube mic designs, the Gemini series, and pulled a 180. The sE Gemini 5 goes where no other mic has gone before, boldly striding into the realm of FET sound. How does it do it? Does the Gemini 5 use some fancy, high-faultin' mic modeling to achieve "real" FET sound? No, silly, it uses a real FET circuit. That's right, you can swap out the tube housing with a real FET circuit and totally switch up the sound. HOW COOL IS THAT!?! On top of that, the Gemini 5 comes with a hardcore flight case and sexy shockmount to match. Order your Gemini 5 from GearNuts.com today, and be the envy of every recording engineer you know tomorrow.sE Electronics Gemini 5 Tube/FET Microphone Features at a Glance:
- 2-mode large diaphragm condenser microphone based on the Gemini II capsule architecture
- Single tube circuit can be swapped out for a FET circuit
- Stylish shock mount and flight case included
Tube Mode:
- Frequency Response: 30Hz-20kHz
- Sensitivity: 25.1mV/Pa -30 +/-1.5dB
- Polar Pattern: Cardioid
- Impedance: 200 Ohms
- Equivalent Noise Level: 18dB (A weighted)
- Max SPL for 0.5% THD@1000Hz: 130dB
- Power Requirement: External PSU included
- Connector: 8-pin
- Frequency Response: 30Hz-20kHz
- Sensitivity: 31.6mV/Pa -30 +/-1.5dB
- Polar Pattern: Cardioid
- Impedance: 200 Ohms
- Equivalent Noise Level: 16dB (A weighted)
- Max SPL for 0.5% THD@1000Hz: 128dB
- Power Requirement: External PSU included
- Connector: 8-pin
|
||||||||||||||||||||||||||||||||












